Product ID:INTERSHIELD PRORECO 508, PRA560
MSDS Date:06/18/1997
FSC:8010
NIIN:00N087931
MSDS Number: CHLPK

COURTAULDS COATINGS INC

2270 MORRIS AVE
UNION, NJ 07083-0386
US

Emergency Phone: 800-854-6813;800-424-9300(CHEMTREC)

Info Phone: 713-684-1563

Cage: 50411

INTERNATIONAL PAINT INC

HOUSTON, TX 77091 US

Telephone: 713-684-1244

Cage: 028S6

2-HEPTANONE; (METHYL N-AMYL KETONE)

CAS: 110-43-0

RTECS: MJ5075000

Fraction By Weight: 25-50%

OSHA PEL 100 PPM

ACGIH TLV: 50 PPM

POLYURETHANE PREPOLYMER WITH ISOPHORONE DIISOCYANATE

CAS: 55636-48-1

Fraction By Weight: 10-50%

OSHA PEL N/K

ACGIH TLV: N/K

POLYESTER POLYOL POLYMER WITH METHLENE BIS(2-CYCLOHEXYL

CAS: 59330-00-6

Fraction By Weight: 10-50%

OSHA PEL N/K

ACGIH TLV: N/K

BIS (4-CYCLOHEXYL ISOCYANATE)

RTECS: 9999999ZZ

OSHA PEL N/K

ACGIH TLV: N/K

INGRED SECTION. B) REMOVE VOLATILES PRODUCED DURING

RTECS: 9999999ZZ

ON SURFACES COATED WITH THIS PRODUCT.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: CAUSES NOSE AND THROAT
IRRITATION. EYE CONTACT: CAUSES EYE IRRITATION. SKIN CONTACT:
CAUSES SKIN IRRITATION. CAN BE ABSORBED THROUGH THE SKIN. MAY CAUSE
ORGAN DAMAGE. INGESTION: MAY BE FAT AL IF SWALLOWED AND MAY CAUSE
ORGAN DAMAGE.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:GENERAL: IN ALL CASES OF DOUBT OR WHEN SYMPS PERSIST, SEEK
MED ATTN. NEVER GIVE ANYTHING BY MOUTH TO UNCON PERSON. INHAL:
REMOVE TO FRESH AIR. IF DISCOMFORT IS PRESENT OR BRTHG IS ABSENT
GET MED ATTN IMMED. EYES: FLUSH IMMED W/PLENTY OF WATER FOR AT
LEAST 15 MIN UNTIL IRRIT SUBSIDES. IF IRRIT PERSISTS, GET MED ATTN.
SKIN: FLUSH W/LARGE AMTS OF WATER. USE SOAP IF AVAILABLE. REMOVE
SEVERELY (SUPDAT)

Flash Point:115F,46C
Lower Limits:1.1%
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICAL.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:ISOLATE FROM HEAT, SPARKS, ELECTRICAL
EQUIP & OPEN FLAME. CLOSED CNTNRS MAY EXPLODE WHEN EXPOSED TO
EXTREME HEAT. IN THE ABSENCE OF ELECTRICITY, WATER (SUPDAT)

Spill Release Procedures:CONTAIN SPILLED LIQUID WITH SAND OR EARTH. DO
NOT USE COMBUSTIBLE MATERIALS SUCH AS SAWDUST. ABSORB SPILL WITH AN
INERT MATERIAL (EG, DRY SAND OR EARTH), THEN PLACE IN A CHEMICAL
WASTE CONTAINER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP CNTNR CLSD. LOOSEN CLOSURE
CAUTIOUSLY BEFORE OPENING. STORE IN A COOL, WELL VENTD PLACE AWAY
FROM INCOMPAT MATLS (SEE STABILITY & REACTIVITY).
Other Precautions:KEEP AWAY FROM HEAT, SPARKS & FLAMES. PROTECT
MATERIAL FROM DIRECT SUNLIGHT. GROUND & BOND CNTNRS WHEN
TRANSFERRING MATERIALS. EMPTY CNTNRS MAY RETAIN HAZARDOUS
PROEPRTIES. FOLLOW ALL MSDS/LABEL WARNI NGS, EVEN AFTER CNTNR IS
EMPTIED.

Respiratory Protection:USE RESPIRATOR APPROVED BY NIOSH AND IN
ACCORDANCE WITH 29 CFR 1910.134 TO REMOVE PARTICULATES (AND VAPORS
IF THERE IS OVEREXPOSURE TO VAPORS GENERATED DURING PROCEDDING OF
THIS PRODUCT).
Ventilation:PROVIDE SUFFICIENT VENT, IN VOLUME & PATTERN, TO A) KEEP
TLV OF HAZARDOUS INGREDS BELOW LIMITS SPECIFIED IN (ING 5)
Protective Gloves:CHEMICAL RESISTANT GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER . AS
NEEDED, USE BODY PROTECTION TO AVOID CONTACT WITH PRODUCT.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
EXPLO HAZ: SPRAY (FOG NOZZLE IS PREFERRED) MAY BE USED TO COOL CNTNRS.
DECOMP & COMBUST PRODS MAY BE TOXIC. FIRST AID PROC: CONTAM CLTHG
(INCLUDING SHOES) & WASH BEFORE REUSE. IF IRRIT PERSISTS, GET M ED
ATTN. INGEST: IF SWALLOWED, DO NOT INDUCE VOMITING. KEEP AT REST.
GET PROMPT MED ATTN.

Boiling Pt:B.P. Text:305F,152C
Vapor Density:HVR/AIR
Spec Gravity:0.97
Evaporation Rate & Reference:SLOWER/ETHER
Appearance and Odor:LIQUID.

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRDCE HAZARDOUS FUMES WHEN HEATED
TO DECOMPOSITION AS IN WELDING. FUMES MAY PRDCE CARBON DIOXIDE &
CARBON MONOXIDE.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND
FEDERAL REGULATIONS. DO NOT INCINERATE UNOPENED CONTAINERS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.